We are glad to share with you about the results of our work, company news, and give you timely developments and personnel appointment and removal conditions.
As shown in the figure below, the belt conveyor is mainly composed of several parts, such as the belt, the transmission roller, the tensioning device, the roller frame and the transmission device
In the process of cutting off the steel pipe, in addition to ensuring that the length of the roller shell is controlled within the specified range, it is also necessary to ensure the chamfering angle. The uneven chamfering of the pipe cutting machine will cause the stop of the car to not be in the center of the roller shell, resulting in the increase of the radial runout of the roller. If the shell length is greater than the requirements of the drawing, the size of the roller shell will be reduced when the shaft head protrudes out, which may cause the roller to not be placed in the roller frame.
In the design of the drive device, couplings are mostly used, and here is a brief introduction to them: couplings are commonly used components in mechanical transmission. It is used to connect the two shafts, and the two shafts cannot be separated when the machine is running; Only after the machine has been stopped and the coupling has been disassembled can the two axes be separated.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies.
Privacy Policy
15 2025-04 
14 2025-04 
10 2025-04 
09 2025-04